Mazda Project
Sunday, February 28, 2010
So it's fixed now!
I had some connections to get that clutch bracket welded, so last friday I had her patched up. I am going to install it this afternoon because it's in the 40's, then adjust the clutch to make sure the engagement point and disengagement point are safe, and were I want them. So here is what I have done so far!
This is what the whole assembly looks like.
It's not a perfect weld, but the guy used $28 rods.
In this picture and the next you can see I added a brace, so in the future it should stay strong.
After I got done putting all parts back on the clutch bracket, you can see I only had 1/16" and 1/32" of an inch on each side of the brace. I am the happiest man on earth, cause I just eyed it. If it were different I would have to do some grinding for all the parts to fit.
Some of the welding. Sorry you can't see the details. lol.
This is what the whole assembly looks like.
It's not a perfect weld, but the guy used $28 rods.
In this picture and the next you can see I added a brace, so in the future it should stay strong.
After I got done putting all parts back on the clutch bracket, you can see I only had 1/16" and 1/32" of an inch on each side of the brace. I am the happiest man on earth, cause I just eyed it. If it were different I would have to do some grinding for all the parts to fit.
Some of the welding. Sorry you can't see the details. lol.
posted by TheSkater at 1:03 PM
1 Comments:
Jeepers Man! Not sure if I understand all of that but cool beans :)
D
Post a Comment
<< Home